beremiz

update PLC status after initialization

2016-12-07, Andrey Skvortsov
1445457547f7
update PLC status after initialization

This is necessary especially if existed PLC program is loaded, but PLC
is not started automatically. In this case taskbar icon shows that PLC
isn't empty.
Beremiz installation
====================
Windows
-------
Download installer, install.
Linux
-----
Pre-requisites::
# Ubuntu/Debian :
sudo apt-get install python-wxgtk2.8 pyro mercurial
sudo apt-get install build-essential bison flex python-numpy python-nevow
Prepare::
mkdir ~/Beremiz
cd ~/Beremiz
Get Source Code::
cd ~/Beremiz
hg clone http://dev.automforge.net/beremiz
hg clone http://dev.automforge.net/plcopeneditor
hg clone http://dev.automforge.net/matiec
Build MatIEC compiler::
cd ~/Beremiz/matiec
./configure
make
Build CanFestival (optional)::
# Only needed for CANopen support. Please read CanFestival
# manual to choose CAN interface other than 'virtual'::
cd ~/Beremiz
hg clone http://dev.automforge.net/CanFestival-3
cd ~/Beremiz/CanFestival-3
./configure --can=virtual
make
Launch Beremiz::
cd ~/Beremiz/beremiz
python Beremiz.py