beremiz

make possible to turn off at compile time online debugging, logging
and external sync functionality

Defines TARGET_DEBUG_DISABLE, TARGET_LOGGING_DISABLE, TARGET_EXT_SYNC_DISABLE
allow to use generated PLC code in low-cost microcontrollers,
integrate into external programs and so on.

main.c:
extern void __run(void);
int main(void)
{
for(;;) {
__run();
// sleep common_ticktime__ ns
// add common_ticktime__ ns to __CURRENT_TIME
}
return 0;
}

Compile for example for arm bare-metal:
../build$ arm-none-eabi-gcc \
-DTARGET_DEBUG_DISABLE -DTARGET_LOGGER_DISABLE
-DTARGET_EXT_SYNC_DISABLE \
-flto -ffunction-sections -fdata-sections -I../../../../matiec/lib/C \
*.c \
-nodefaultlibs --specs=nano.specs -Wl,--static -Wl,--gc-section -Wl,--start-group -lc -lm -lnosys -lgcc -Wl,--end-group
Beremiz installation
====================
Windows
-------
Download installer, install.
Linux
-----
Pre-requisites::
# Ubuntu/Debian :
sudo apt-get install python-wxgtk2.8 pyro mercurial
sudo apt-get install build-essential bison flex python-numpy python-nevow
Prepare::
mkdir ~/Beremiz
cd ~/Beremiz
Get Source Code::
cd ~/Beremiz
hg clone http://dev.automforge.net/beremiz
hg clone http://dev.automforge.net/plcopeneditor
hg clone http://dev.automforge.net/matiec
Build MatIEC compiler::
cd ~/Beremiz/matiec
./configure
make
Build CanFestival (optional)::
# Only needed for CANopen support. Please read CanFestival
# manual to choose CAN interface other than 'virtual'::
cd ~/Beremiz
hg clone http://dev.automforge.net/CanFestival-3
cd ~/Beremiz/CanFestival-3
./configure --can=virtual
make
Launch Beremiz::
cd ~/Beremiz/beremiz
python Beremiz.py