beremiz

SVGHMI: JsonTable now use intermediate variables again to address JSON data without duplicating code or referencing. Using intermediate variables also alows to check for availability of data and stop evaluating early if data is missing. Finally added complete roundtrip example to illustrate use of JSonTable to display "alarms" collected in python from changes on PLC boolean variables.
svghmi
2020-08-25, Edouard Tisserant
4930455428df
SVGHMI: JsonTable now use intermediate variables again to address JSON data without duplicating code or referencing. Using intermediate variables also alows to check for availability of data and stop evaluating early if data is missing. Finally added complete roundtrip example to illustrate use of JSonTable to display "alarms" collected in python from changes on PLC boolean variables.
Beremiz installation
====================
Windows
-------
Download installer, install.
Linux
-----
Pre-requisites::
# Ubuntu/Debian :
sudo apt-get install python-wxgtk2.8 pyro mercurial
sudo apt-get install build-essential bison flex python-numpy python-nevow
Prepare::
mkdir ~/Beremiz
cd ~/Beremiz
Get Source Code::
cd ~/Beremiz
hg clone http://dev.automforge.net/beremiz
hg clone http://dev.automforge.net/plcopeneditor
hg clone http://dev.automforge.net/matiec
Build MatIEC compiler::
cd ~/Beremiz/matiec
./configure
make
Build CanFestival (optional)::
# Only needed for CANopen support. Please read CanFestival
# manual to choose CAN interface other than 'virtual'::
cd ~/Beremiz
hg clone http://dev.automforge.net/CanFestival-3
cd ~/Beremiz/CanFestival-3
./configure --can=virtual
make
Launch Beremiz::
cd ~/Beremiz/beremiz
python Beremiz.py