beremiz

Fix non-usable toolbar on wxPython with GTK3+ in PLCOpenEditor

2018-08-29, Andrey Skvortsov
69fefac5760e
Fix non-usable toolbar on wxPython with GTK3+ in PLCOpenEditor

this problem is related to 'Fix non-usable toolbar on wxPython with
GTK3+' (5927710b). This problem does not happen in Beremiz because
additional necessary self.AUIManager.Update() is called
BeremizIDE. Therefore minimal change in the mentioned commit was
enough for Beremiz, but is not enough for PLCOpenEditor.
Beremiz installation
====================
Windows
-------
Download installer, install.
Linux
-----
Pre-requisites::
# Ubuntu/Debian :
sudo apt-get install python-wxgtk2.8 pyro mercurial
sudo apt-get install build-essential bison flex python-numpy python-nevow
Prepare::
mkdir ~/Beremiz
cd ~/Beremiz
Get Source Code::
cd ~/Beremiz
hg clone http://dev.automforge.net/beremiz
hg clone http://dev.automforge.net/plcopeneditor
hg clone http://dev.automforge.net/matiec
Build MatIEC compiler::
cd ~/Beremiz/matiec
./configure
make
Build CanFestival (optional)::
# Only needed for CANopen support. Please read CanFestival
# manual to choose CAN interface other than 'virtual'::
cd ~/Beremiz
hg clone http://dev.automforge.net/CanFestival-3
cd ~/Beremiz/CanFestival-3
./configure --can=virtual
make
Launch Beremiz::
cd ~/Beremiz/beremiz
python Beremiz.py