beremiz

fix splash loading with wx3.0

2016-04-20, Andrey Skvortsov
9c22ff9c8c06
fix splash loading with wx3.0

Previously only gray square was shown. Apparently to show splash screen several calls of wx.Yield() are necessary.
Unfortunately splash.IsShowOnScreen() returns always 1 regardless of whether splash is on the screen or not.
this fix is a dirty hack. It just process all events after splash is created during 0.3 seconds.
Beremiz installation
====================
Windows
-------
Download installer, install.
Linux
-----
Pre-requisites::
# Ubuntu/Debian :
sudo apt-get install python-wxgtk2.8 pyro mercurial
sudo apt-get install build-essential bison flex python-numpy python-nevow
Prepare::
mkdir ~/Beremiz
cd ~/Beremiz
Get Source Code::
cd ~/Beremiz
hg clone http://dev.automforge.net/beremiz
hg clone http://dev.automforge.net/plcopeneditor
hg clone http://dev.automforge.net/matiec
Build MatIEC compiler::
cd ~/Beremiz/matiec
./configure
make
Build CanFestival (optional)::
# Only needed for CANopen support. Please read CanFestival
# manual to choose CAN interface other than 'virtual'::
cd ~/Beremiz
hg clone http://dev.automforge.net/CanFestival-3
cd ~/Beremiz/CanFestival-3
./configure --can=virtual
make
Launch Beremiz::
cd ~/Beremiz/beremiz
python Beremiz.py