beremiz

Fix problem with decreasing size of StatusToolBar when tools are removed from toolbar.

2018-07-30, Andrey Skvortsov
f6a0508fa473
Fix problem with decreasing size of StatusToolBar when tools are removed from toolbar.

StatusToolBar - toolbar with tool to build, clear, connect, ...
This problem appears only in python-wxgtk3.0. In python-wxgtk2.8 there
was not such problem.

If call StatusToolBar.SetMinSize(wx.DefaultSize), all is working, but
following warning message appears:

(Beremiz.py:15155): Gtk-WARNING **: 18:42:24.115: Negative content
width -6 (allocation 1, extents 4x3) while allocating gadget (node
toolbar, owner GtkToolbar)

To avoid that StatusToolBar.GetToolBitmapSize() is used instead of wx.DefaultSize
Beremiz installation
====================
Windows
-------
Download installer, install.
Linux
-----
Pre-requisites::
# Ubuntu/Debian :
sudo apt-get install python-wxgtk2.8 pyro mercurial
sudo apt-get install build-essential bison flex python-numpy python-nevow
Prepare::
mkdir ~/Beremiz
cd ~/Beremiz
Get Source Code::
cd ~/Beremiz
hg clone http://dev.automforge.net/beremiz
hg clone http://dev.automforge.net/plcopeneditor
hg clone http://dev.automforge.net/matiec
Build MatIEC compiler::
cd ~/Beremiz/matiec
./configure
make
Build CanFestival (optional)::
# Only needed for CANopen support. Please read CanFestival
# manual to choose CAN interface other than 'virtual'::
cd ~/Beremiz
hg clone http://dev.automforge.net/CanFestival-3
cd ~/Beremiz/CanFestival-3
./configure --can=virtual
make
Launch Beremiz::
cd ~/Beremiz/beremiz
python Beremiz.py